Finally the finish line
When in the research and development phase, the finish line can almost seem non-existent. Take that with joy, that most people can not do the things you are doing right now in this moment. Also, you are solving problems that you will not have to deal with if you had released an unfinished project, because it is not a product until it has been tested.
Each one has something different
So now that we are close to solving all the bugs now we (you) have to figure out how to make an instruction packet for the people who have not used this product. That’s crazy, right? You made a product, and now people want it! now let’s pack it up and give them a sticker too, because who doesn’t love a sticker with their order? Once that day comes when you finally finish and sell the first one, then the development phase starts all over again!
I find I spend a long time doing these install pages
I like to use AI for most of my page just to make sure everything looks and sounds good, but my blog will always be the place where it’s just me typing my thoughts to those who will read this. All so if you would check out my YouTube channel.
Thank You!
Keeping organized is the key to success
Spent some time trying to add a storage compartment to my new slide skid design. That way I can utilize it in any truck and be able to winch it up on a trailer for easy deployment of welder system. Came across two sliding rails 250 lb Capable with a locking tab. Cut out some diamond plate left over from making the slide-off skid and fabricated a simple drawer with a c channel handle
Small steps
It all begins with an idea.
As of last week, I have been able to spend some time learning on the new tool for Welding Services. We now have a portable CNC Plasma table capable of 15” x 24” work sizes. This Arc Droid CNC is amazing. The things I have been able to make have taught me a lot about CNC and making parts with it. I can’t wait to make some products for you all to enjoy. If you know of a part you would like made, please reach out.
this was taken at about 1Am
time is the biggest enemy
Make it stand out
first go around with learning how to set the speed and amperage